Zanussi ZHC6234X

We chose Zannusi as they are a well known brand. Despite less than average use. Oven stained badly within 12 months. After 14 months the extractor hood lights ceased to work. Again below average use. Hob surface scratched due to rough underside of pan...

it looks good ,works well ,not too noisy was fitted very easily

This product seems to be well made and looks good with its clean straight lines. Fan works well. My wife and I fitted it relatively easily in a couple of hours using previously installed electric supply and vent outlet. Very pleased with result.

I've had mine six months and the inside of the hood and fan mechanism are getting covered in grease. The open gauze 'grease filter' just isn't enough. The grease also pools and then drops back down onto the hob. You will need to buy the additional...

I've had mine six months and the inside of the hood and fan mechanism are getting covered in grease. The open gauze 'grease filter' just isn't enough. The grease also pools and then drops back down onto the hob. You will need to buy the additional...

It looks fine and seems to do the job OK. Not too happy with the edges where the upper and lower chimneys slide in. The top fixing to the bracket seems over fiddly. I feel the vented offering would benefit from a grease filter and not just the wire...

It looks fine and seems to do the job OK. Not too happy with the edges where the upper and lower chimneys slide in. The top fixing to the bracket seems over fiddly. I feel the vented offering would benefit from a grease filter and not just the wire...

I received this product as part of a package kitchen.When assembleing the product I found that the extendable chimney did not fit together properley and had to be replaced. I was assured by the agent that there was no problem with the part but even so...

I received this product as part of a package kitchen.When assembleing the product I found that the extendable chimney did not fit together properley and had to be replaced. I was assured by the agent that there was no problem with the part but even so...